Wire the motor, Haas recommends to follow the motor wiring shown in this image.
NOTE: Motor wire colors can vary from vendor to vendor.
Please verify the following Conveyor Motion after wiring the motor:
When power is applied to black and red cable leads (“CHIP FWD” button on Haas control), conveyor moves in the forward direction, i.e., pushes chips out.
When power is applied to black and white cable leads (“CHIP REV” button on Haas control), conveyor moves in the reverse direction, i.e., pulls chips in.
NOTE: The wiring of white and red leads can be swapped to change the direction of the motor.